Snapmaker Artisan 3-in-1 3D Printer & Case

With the Artisan 3-in-1 3D printer & housing from Snapmaker you can create large objects of 400mm x 400mm x 400mm. Start print jobs via the large 7-inch (17.78cm) touchscreen. Thanks to the intuitive design, you can navigate through the menu effortlessly. Quick-change platforms and tools allow you to switch between 3 functions in 1 minute. The Artisan is equipped with a double extrusion 3D printing module that supports PVA, HIPS and other soluble materials. Thus complex geometry is no longer a problem. Breakaway printing is also possible. The center of the zone heated bed contains a high temperature zone of 260mm x 260mm which can reach 110°C. Place your model in the inner zone so that the outer zone does not heat up. This saves you not only time but also energy.

Get the printer calibrated in 3 easy steps so you can enjoy printing in 2 materials or 2 colours with perfect adhesion and alignment. The Snapmaker 3D printer is equipped with powerful lasers to cut quickly and deeply into materials and deliver refined laser engravings. The device is suitable for a variety of materials, including leather, brick, stainless steel and anodized aluminum. The wide-angle camera captures your material in one shot and instantly previews your laser job in the Artisan Luban software.

The printer has the following features:

• Door detection sensor, gyro sensor and temperature sensor
• Process various materials such as beech, jade, plywood and HDF
• 0.2mm dimensional accuracy
• Triangulation technology to calculate the thickness of materials
• Ultra-fine laser focus (0.05mm x 0.2mm)
• 10W power
• Double sided sheet with glossy glass and PEI coating