E3D v6 hot end complete kit | 1.75mm 12V thermistor cartridge

This complete v6 hot end kit for your RepRap 3D printer contains all the parts for the v6 hot end (1.75mm), which allows printing at higher temperatures. The hotend kit comes with a thermocouple, capable of reaching temperatures of up to 400°C (additional electronics may be required to support this).

The kit contains the following parts:

• E3D aluminium heater block
• E3D heat break
• E3D brass nozzle (0.4mm)
• E3D injection molded fan duct
• E3D silicone sock for v6 hot ends (3 pieces!)
• E3D aluminium heatsink

The kit contains the following compatible parts:

• Thermocouple type K cartridge 1m
• Axial fan 30 x 30 x 10mm 12V
• Ceramic heating cartridge 12V
• PTFE tube, 10cm
• Fasteners

For the Marlin firmware you need the following thermistor setting: #TEMP_SENSOR_N 5