E3D v6 hot end complete kit | 1.75mm 12V thermistor cartridge

This complete v6 hotend kit for your RepRap 3D printer contains all parts for the v6 hotend (1.75mm). This allows printing at higher temperatures. The hotend kit comes with a thermistor cartridge, with which temperatures up to 300°C can be reached.

The kit contains the following original parts:

• E3D thermistor cartridge 100k Ohm Semitec
• E3D aluminium heater block
• E3D heat break
• E3D brass nozzle (0.4mm)
• E3D injection molded fan duct
• E3D aluminium heatsink
• E3D silicone sock for v6 hotends ( 3 pieces!)
• Fasteners

The kit contains the following compatible parts:

• Axial fan 30 x 30 x 10mm 12V
• Ceramic Heating Cartridge 12V 40W
• PTFE tube, 10cm

For the Marlin firmware you need the following thermistor setting:
#TEMP_SENSOR_N 5