This complete V6 hotend kit (24V Direct Drive) for your 3D printer contains all parts for the v6 hotend (2.85 mm). This allows printing at higher temperatures. The hotend kit comes with a thermistor cartridge, with which temperatures up to 300°C can be reached. A wide range of filaments can be used, allowing experimentation with advanced materials and printing in different resolutions and sizes.
The kit contains the following parts:
- E3D Thermistor cartridge
- E3D aluminum heater block
- E3D heat sink
- E3D heat break
- E3D brass nozzle (0.4mm)
- E3D injection molded fan duct
- E3D silicone sock for v6 hotends (1 piece)
- E3D Ceramic heating cartridge 24V
- E3D v6 Direct Drive coupling 2.85mm
- PTFE tube, 10cm
- Fan 30mm x 30mm x 10mm 24V
- Fasteners
- extension cable
