BuildTak FlexPlate PEI 3-piece system for Ultimaker S5, 260mm x 354mm

The BuildTak FlexPlate system with PEI adhesive platform film allows you to easily remove your 3D prints from the print bed!

The set consists of a flexible circuit board, a magnetic mounting plate and one sheet of PEI adhesive platform foil. All designed to make removing your print as easy as possible. All you need to do is bend the FlexPlate so that the print pops off on its own!

Mounting this set is also super easy: remove the adhesive strip from the magnetic mounting plate to attach it to your print bed, stick the adhesive platform foil on the FlexPlate and attach the whole to the magnetic surface. Done!

This variant of the FlexPlate system is only suitable for the Ultimaker S5, has a print bed surface of 260mm x 354mm and is produced in the United States.

TIP: To avoid printing problems, adjust the height of your Z-axis to compensate for the thickness of the new print bed.