Creality 3D CR-10 Max 3D Printer

The Creality 3D CR-10 Max 3D printer comes with an included stabilisation kit, also called the golden triangle, which ensures unprecedented stability in the printer.
By using a double Z-axis, the X-sled is better supported and this results in better prints.

The print surface of the printer is 450mm x 450mm x 470mm, making this one of the largest in its category. Unlike its predecessors, the heated bed of the Creality 3D CR-10 Max uses its full size for heating. The heated bed has its own power supply so it can be heated very quickly.

After a correct calibration of the BLTouch sensor, you no longer have to worry about a poorly adjusted heatbed. The sensor works simply, smartly and accurately. The advantage of the sensor is that it retracts automatically after use so that it does not get in the way during 3D printing.

Because the printer has such a large bed, the double belt drive ensures that the bed is effortlessly steered forwards and backwards.

The recovery function of the 3D printer comes in handy when the voltage drops. The CR-10 Max also has a filament detection sensor. Is the filament running out? Then the 3D printer will pause automatically. All cabling is quick and easy to connect with two multi connectors located on the electronics housing.

Instead of a standard Bowden tube, this printer also comes with the premium Capricorn Bowden tube, this Bowden tube ensures a better flow of the filament and is much more resistant to the high temperatures of the hotend.

In addition, an extruder is used that uses the same technique as a Bondtech extruder, the filament is fed effortlessly through the use of a double gear.

The printer can be used standalone by using the SD card slot. It is therefore not necessary to always connect the 3D printer to a PC, and with the material detection sensor, the printer will never continue printing without filament.


The printer comes with the following:

• Scraper
• Power cable
• PLA test filament
• USB cable
• Additional nozzle (0.4 and 0.8)
• Extra pneufit
• Micro SD card + USB adapter
• Set block for Z-axis
• Mounting tools
• Side cutting pliers
• Tie wraps